The display should show the current zone number. Use both eye and ear protection. If the needle falls below the normal range, stop the vehicle, turn off the engine and check the engine oil level. Lift handle to move seat forward or backward. Driving while distracted can result in loss of vehicle control, accident and injury.
Use a tire gauge to check the tire inflation pressure, including the spare if equipped , at least monthly and before long trips. Drive slowly to the closest safe area out of traffic. Note: If the bulb is accidentally touched, it should be cleaned with alcohol before being used. To install the new bulb, follow the removal procedures in reverse order. Never touch the playing surface. Failure to follow the specific warnings and instructions could result in personal injury. A market unique supplement may be supplied that complements this book.
Engine oil pressure gauge: Indicates engine oil pressure. If your vehicle has been operated for an extended period at high speeds, in city traffic during hot weather or pulling a trailer, the vehicle should be turned off for about 30 minutes to allow fluid to cool before checking. Return to the center position to disable the adjust function. If your vehicle is equipped with a Diesel engine, it has a unique cluster, refer to Starting the engine in your 6. Replacing headlamp bulbs sealed beam 1.
Replacing headlamp bulbs aerodynamic 1. They may seriously injure themselves. Press the control again to select Trip A and Trip B features. Continued driving with this light on may cause the Service Engine Soon warning light to come on, refer to Fuel filler cap in the Maintenance and Specification chapter. The recorded information may assist in the investigation of such an event. Remove bulb socket from lamp assembly by turning counterclockwise. If there are less than six strong stations, the system will store the last one in the remaining presets.
Therefore, the vehicle will not be prevented from moving when a rear wheel is lifted, even if the parking brake is applied. Re-start the engine and take your vehicle to an authorized dealer. Do not use fuel lines, engine rocker covers or the intake manifold as grounding points. Do not use the power point for operating the cigarette lighter element if equipped. High fluid level Fluid levels above the safe range may result in transmission failure. When turning, make wider turns so the trailer wheels will clear curbs and other obstacles.
Hoses are located in the rear exterior, driver side storage bin, as well as just above the valve. The emission system heats up the engine compartment and exhaust system, which can start a fire. See the following for a brief description on each control. Chilton's Ford E-450 Super Duty repair manuals include diagrams, photos, and instructions you need to assist you in do-it-yourself E-450 Super Duty repairs. If it enters the red section, the engine is overheating. A significant decrease in braking performance may occur.
Do not place objects on top of the instrument panel as these objects may become projectiles in a collision or sudden stop. In freezing weather, be sure the wiper blades are not frozen to the windshield before operating the wipers. However, in some climates, you may need to use snow tires and chains. Return to the center position to disable the adjust function. Remove the jumper cable from the ground metal surface. To prolong the life of the wiper blades, it is highly recommended to scrape off the ice on the windshield before turning on the wipers.
After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. After the odometer is displayed, press and release the reset button 10 times within 60 seconds. For additional information, please contact the Truck Body Builders Advisory Service at 1—877—840—4338. The vehicle will change to 10 minutes for courtesy lamps and 30 minutes for demand interior lamps once the odometer reads over 50 miles. This may scratch the glass, damage the wiper blades and cause the wiper motor to burn out. The kit to enable Satellite reception is available through your dealer. Please contact your authorized dealer for further information.